EasyManua.ls Logo

Geeetech A10 - Page 12

Geeetech A10
59 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SHENZHEN GETECH TECHNOLOGY CO,.LTD
8
Note: If the operating system is Mac OS, please set the baud rate of the firmware and Repetier Host as
115200.
Open the firmware in Arduino, and modify the baud rate to 115200 in Configuration.h. Shown as
following picture.
After modification, re-upload the firmware:

Table of Contents

Related product manuals