It will automatically print after heating is finished.
9.FAQ
If you have any problem when you use the printer, you can visit our forum http://www.geeetech.com/forum/ There
are detailed solutions on the forum. FAQ are as follows.
9.1 How to upload the firmware?
9.1.1 Upload the firmware in Win7 OS
To upload the firmware, we need following tools:
1.Arduino IDE
Arduino1.0.1 is recommended, and you can download it here:
http://www.geeetech.com/wiki/images/a/a2/Arduino-1.0.1-windows.zip
2. The firmware for the printer
A10 uses GT2560 control board. Download the firmware of A10 here:
http://www.geeetech.com/forum/viewtopic.php?f=20&t=17046
After Arduino and firmware are downloaded, you can upload the firmware. First please connect the printer
To Next Page
Loading...
