Set the parameters as shown in the picture
Travel Feed Rate: 3000 mm/min
Z-axis Feed Rate: 100mm/min
We suggest you to cancel the option of Go to Park Position after Job/Kill, or it may cause that the print
head impacts the printed model when it moves to starting position after finishing printing.
4.4 Extruder
In the
“
Extruder
”
tab you can define the numbers of extruder, the max temperatures, that are shown in the
manual control. The max volume per second defines the maximum amount of filament in mm
³
, the extruder
can melt per second.
To Next Page
Loading...
