Geeetech Mizar S - Filament Change and Axis Movement

Change
Filament
Custom
10
2.2 Change Filament.
PLA: 
after the preheating starts, the printer will always be in the preheating state.

"Cool" icon to end the preheating.
ABS: 
after preheating, the printer will always be in preheating state. If you want to

the preheating.
Cool: 
Custom: Custom preheating temperature.








Press this icon to switch between hotbed and nozzle.
Step value of temperature for each click on the adjust
temperature icon.

Increase temperature.
Decrease temperature.




