18
10
LOADING FILAMENT
1.
inoperable, indicating use the user did not enter the "Leveling" page
2.
hot end will move to the middle of the hot bed. At this time, please
place a piece of A4 paper between the nozzle and the hot bed,
adjust the up and down arrow icons on the interface, and move The
position of the nozzle (on the page, you can adjust the icon for each
motor to move up and down, and the distance the nozzle moves.
When the nozzle is close to the hot bed, it is recommended to switch
to a smaller scale to avoid damaging the nozzle and hot bed), and
move A4 Paper, take A4 paper just rubbed to the nozzle as the best
complete the adjustment of the distance between the nozzle and the
hot bed.
1.
interface, and then click the "Load" icon. At this time, the
are disabled, please wait patiently.
Heating
2.
After heating the nozzle, the system will remind you to
start loading the consumables.
Save
Confirm
¡
Cancel
To Next Page
Loading...
Need help?
General
