To Next Page

To Previous Page

Pull the belt of the X&Y axis by hand to check whether the tightness is appropriate. If it is too loose or too tight, please use the belt tensioner on the X&Y side

to adjust(When Mizar S leaves the factory, the belt tensioners use ordinary screws. If necessary, you can replace them with the plastic handle screws in the

accessories that can be adjusted manually).

3 Check the X&Y axis belt.

9.4 MIZAR S power supply has two voltage ranges of 230V and 115V. Please select the voltage range according to the country or region where you are located

and ensure that the voltage range is in the correct position. Otherwise, the power supply will be damaged. Please make sure, then power on the printer.

CHECK POWER SUPPLY

115