gefran ADP200

46 ADP200 • Quick installation guide - Specifications and connection
8. Use of the keypad
This chapter describes the integrated keypad and the optional KB-ADV100 keypad and methods of use for displaying
and programming inverter parameters.
8.1 Description of keypads
8.1.1 KB-ADP200 integrated keypad
→
Drive status indicator LEDs
→
Prg
Enter
FWD n=0ILIMENREV AL
CAN
←
LCD display (4 characters + sign)
→
Membrane keypad
The integrated programming keypad is used to display status and diagnostics parameters during operation.
8.1.1.1 Membrane keypad
This section describes the keys on the membrane keypad and their functions
Symbol Reference Description
Prg
Returns to the higher level menu or submenu.
Exits a parameter, and a list of parameters.
It can be used to exit an error or alarm message.
Enter Enter
Enters the submenu or selected parameter, or selects an operation.
It is used when modifying parameters to confirm the new value that has been set.

Up
Moves the selection up in a menu or list of parameters.
During modification of a parameter, increases the value of the blinking digit.

Down
Moves the selection down in a menu or list of parameters.
During modification of a parameter, decreases the value of the blinking digit.
8.1.1.2 Meaning of LEDs
There are 7 drive status indicator LEDs on the front of the ADP200 drive.
LEDs Colour Meaning of LEDs
FWD Yellow Motor is rotating in forward direction
REV Yellow Motor is rotating in reverse direction
EN Green The LED is lit during IGBT modulation (drive operating)
ILIM Red When this LED is lit the drive has reached a current limit condition. During normal functioning, this LED is off.
N=0 Yellow The LED is lit when motor speed is 0.
AL Red The LED is lit when the drive signals that an alarm has been triggered
CAN Green The LED is only present in types ADP200.-...-C.
LED flashes = pre-operational.
LED stays on = operational.
LED off = Stop.