ADP200 • Quick installation guide - Specifications and connection 53
8.2.8 Motor self-tuning
From Startup wizard Run Autotune still to enable motor self-tuning.
The following warning messages are displayed at the start and end of Self-tuning:
Operations displayed on the optional keypad Operations displayed on the integrated keypad
Close Enable input C EN
Open Enable input O EN
When the self-tuning procedure is executed its progress is displayed. In this phase the rst digit on the right indicates
the progress of the procedure by rotating the external segments of the display.
If an error occurs, the word Er is displayed with the error code. Press Prg to exit the error.
Note ! For further information see chapter "9.2 Startup wizard for brushless motors (with the optional keypad)
To Next Page
Loading...
