66 ADP200 • Quick installation guide - Specifications and connection
Step 8 - Setting application parameters
Not used.
Press keys.
Step 9 - Save parameters
To save the new parameter settings, so that they are maintained also after power-off, proceed as follows:
SA
v
E
Enter
85 50
Enter
8
E.
nt
.
Enter
do.nE.
(1) (2) (3) (4)
(1) Press the Enter key to start the save parameters procedure.
(2) Press Enter to conrm
(3) End of procedure
(4) When the parameters have been saved correctly the drive displays this screen to show that the startup wizard is
complete.
Press the Prg (x3s) key.
Proceed to the next step.
Application set-up
Refer to PID-IMM Application manual for detailed Set-up procedure.
To Next Page
Loading...
