ADP200 Application PID-IMM User Manual Pag. 28 of 80
Step 7 – Motor overload setting
Enabling of the motor overload control, setting of the motor overload value (the value is expressed as a
percentage of Rated current PAR 2002 * Motor service factor PAR 3206 and setting of the motor overload
duration in seconds).
If used, enables entering of motor overload values.
Next page.
Step 8 – Motor overtemperature setting
Motor OT protection management: selection of the source, threshold and sensor type setting, behaviour of
the drive in case of a motor overtemperature alarm.
Next page.
To Next Page
Loading...
