PRINTED IN U.S.A. 21 913323/CP0112
GUARDS AND SHIELDS
Whenever possible and without affecting machine
operation, guards and shields are used to protect poten-
tially hazardous areas. In many places, decals are also
provided to warn of potential hazards and to display
special operating procedures.
WARNING
Read and thoroughly understand all safety
decals on the Telescopic Handler BEFORE
operating it. DO NOT operate the machine
unless all factory-installed guards and shields
are properly secured in place.
Chapter 5
INDICATORS AND CONTROLS
Operator’s Compartment and Indicators/Controls Locations
Frame Angle
Indicator
Boom Control
Joystick
Key Switch, Start
and Horn Button
Boom Angle
Indicator
Brake
Pedal
Frame Level and
Attachment Joystick
Throttle Pedal
Steering
Wheel
Load Zone
Charts
Speed and Travel
Direction Lever
Auxiliary
Hydraulics Control
Instrument and
Switch Panel
Brake Fluid
Reservoir
Two Joystick Controls
Tri-Function Joystick Control
Tri-Function
Joystick
Frame Level
Control
CAUTION
Become familiar with and know how to use
ALL safety devices and controls on the
Telescopic Handler BEFORE operating it.
Know how to stop the machine operation
BEFORE operating it. This Gehl machine is
designed and intended to be used ONLY with
a Gehl Company attachment tool, or a Gehl
Company approved accessory or referral
attachment tool. Gehl Company cannot be
responsible for product safety if the machine
is used with a non-approved accessory or
attachment tool.
To Next Page
Loading...
Need help?
General
