PRINTED IN U.S.A. 41 913323/CP0112
2. The ramps MUST be firmly attached to the truck
or trailer bed with NO step between the bed and
the ramps.
3. The incline of the ramps MUST be less than 15
degrees. For a four-foot high truck bed, ramp
length must be at least 16 feet (4.9 m) long.
4. Ramp width MUST be at least 1-1/2 times the tire
width.
5. Block the front and rear of the tires on the truck or
trailer. Engage the parking brake.
6. Position the machine with the boom facing toward
the front of the truck or trailer so that it is straight
in line with the ramps.
7. Slowly (at the lowest engine speed possible) and
carefully drive the machine up the ramps.
8. Secure the machine to the bed of the truck or trail-
er with tie-down chains/cables.
Unloading Machine Using Ramps
NOTE: A matched pair of ramps is required.
Repeat steps 1 through 5 and proceed as follows to
unload the machine:
6. Remove the tie-down chains/cables.
7. If necessary, adjust the machine so that the wheels
are in line and centered with the ramps.
8. Slowly (at the lowest engine speed possible) and
carefully drive the machine down the ramps.
THEFT DETERRENTS
Gehl Company has recorded all major component part
numbers and serial numbers. Users should take as
many of the following actions as possible to discour-
age theft, to aid in the recovery of the machine in the
event it is stolen, and to reduce vandalism:
1. Remove keys from unattended machines.
2. Attach, secure, and lock all anti-vandalism and
anti-theft devices on the machine.
3. Lock doors of cabs when not in use.
4. Inspect the gates and fences of the equipment stor-
age yard. If possible, keep machines in well-light-
ed areas. Ask the local law enforcement agency to
make frequent checks around the storage and work
sites, especially at night, during weekends, and on
holidays.
5. Report any theft to your dealer and insurance com-
pany. Provide the model and serial numbers.
Request your dealer to forward this information to
Gehl Company.
WARNING
NEVER adjust travel direction (even slightly)
while traveling on the ramps. Instead, back
down off the ramps, and then realign the
machine with the ramps.
WARNING
NEVER transport the machine with the boom
raised or extended. BE SURE to secure the
machine to the truck or trailer bed using chain
and binders or steel cables, to prevent any
movement while transporting.
To Next Page
Loading...
Need help?
General
