Gehl RS6-34 Operator's Manual

PRINTED IN U.S.A. 61 913323/CP0112
Problem
PWP System switch lamp flash-
es when switch is pressed “ON.”
Parking brake does not engage
when the PWP System switch is
pressed “ON.”
Carriage tilt and auxiliary func-
tions continue operating when
the PWP System switch is
pressed “ON.”
Transmission does not remain
de-clutched when shifted into
“Forward or Reverse” when the
PWP switch is “ON.”
Boom control functions do not
operate.
PWP System switch lamp flash-
es when switch is turned “OFF.”
Parking brake switch lamp stays
“ON” when PWP System switch
is “OFF.”
Possible Cause
PWP System is not activated.
Machine is not level.
PWP System remote shutdown
switch is disengaged.
PWP System remote shutdown
switch is not plugged into the
connector at the end of the
boom.
PWP System angle sensor is
unplugged or faulty.
PWP System is not de-activated.
Remedy
With PWP System switch “ON,”
apply service brakes for three
seconds until PWP switch lamp
is lit continuously.
Level the machine.
Engage the PWP System
remote shutdown switch.
Plug in and engage the PWP
System remote shutdown
switch.
Contact your Gehl dealer for
assistance.
With engine running, apply ser-
vice brakes for three seconds
until PWP switch lamp goes off.
PWP SYSTEM TROUBLESHOOTING

Gehl RS6-34 Specifications

General

Engine Power	74 hp
Maximum Lift Capacity	6614 lbs
Max Forward Reach	22 ft
Rated Capacity	6, 000 lbs
Max Reach at Ground Level	22 ft
Hydraulic System Flow	26.4 gpm