PRINTED IN U.S.A. 43 913323/CP0112
All Grease Fittings
Use No. 2 lithium-based grease
Brake System
Use Multi-ATF Dexron
®
III or equivalent
GENERAL INFORMATION
NOTE:
The Maintenance chapter (Chapter 10)
in this manual has provisions for recording the
dates and hourmeter readings after lubrication or
other service has been performed; use those
spaces to keep a log for maintaining a current ser-
vice interval record. Proper routine lubrication is
an important factor in preventing excessive part
wear and early failure.
LUBRICANTS
The chart on this page lists the locations, temperature
ranges and recommended types of lubricants to be used
when servicing the machine. Refer to the separate
engine manual for additional information regarding
recommended engine lubricants, quantities and grades
required.
NOTE: Refer to Operator Services topic in the
Service and Storage chapter of this manual for
detailed information regarding periodic checking
and replenishing of lubricants.
Chapter 7
LUBRICATION
WARNING
NEVER lubricate or service this unit when any
part of the machine is in motion. ALWAYS
exercise the MANDATORY SAFETY SHUT-
DOWN PROCEDURE (p. 8, SAFETY chapter)
before lubricating or servicing this equipment.
Hydraulic System Reservoir
Use Mobil DTE 15M, or an equivalent that
contains anti-rust, anti-foam and anti-oxida-
tion additives and conforms to ISO VG46/VG32.
Capacity: 35 gallons (133 liters)
Engine Crankcase Oil
Ambient Temperature Grade*
-22°F - 104°F (-30°C - 40°C) SAE 5W-30
-40°F - 122°F (-40°C - 50°C) SAE 0W-40
-13°F - 104°F (-25°C - 40°C) SAE 10W-30
-13°F - 122°F (-25°C - 50°C) SAE 10W-40
5°F - 122°F (-15°C - 50°C) SAE 15W-40
*API Service Classification: CJ-4/Cl-4 PLUS/CI-4
*API Service Classification for first 100 hours on new or
rebuilt John Deere engines: CE, CD, or CC
Capacity: 15.5 quarts (14.7 liters)
Diesel Fuel
84 hp Tier 3 Engine: Use only low sulfur
(LSD) or ultra low sulfer (ULSD) diesel
fuel. Sulfur content of 1000 PPM or below speci-
fied to EN590 or ASTM D975 is strongly recom-
mended.
74 hp IT4 Engine: Use only ultra low sulfer
(ULSD) diesel fuel with a maximum of 15 PPM
sulfer content specified to EN590 or ASTM D975.
Axle Gear Oil
MobilFluid
®
424 (recommended)
API GL4/GL5 80W with Wet Brake Additive
(Gehl Wet Brake Additive part number L71456)
Differential capacity: 9.6 quarts (9.0 liters)
Planetary capacity: 0.6 quarts each (0.5 liters)
Transmission Oil
Use Multi-ATF Dexron
®
III or equivalent
Capacity: 24 quarts (23 liters)
To Next Page
Loading...
Need help?
General
