Gema OptiStar CG08-C - Page 4

V 02/18
2 • Table of contents OptiStar CG08(-C)
Select predefined operating mode (Preset mode) .................................. 31
Starting the user-defined operating mode (Program mode) .................... 31
Setting powder output and powder cloud ................................................ 32
Setting the electrode rinsing air ............................................................... 33
Correction values .................................................................................................. 33
Entering the correction values ................................................................. 33
Powder output/powder hose correction ................................................... 34
Correction factor - diagram ...................................................................... 36
Cleaning mode ..................................................................................................... 37
Activating the cleaning function ............................................................... 37
Monitoring of wearing parts and trigger counter ................................................... 38
Trigger counter ........................................................................................ 38
View remaining service life ...................................................................... 39
Deactivation of wearing part monitoring .................................................. 40
Setting the background illumination ..................................................................... 40
Activate/deactivate the keyboard lock .................................................................. 41
Checking the software version ............................................................................. 41
RAM Reset ........................................................................................................... 41
Shutdown .............................................................................................................. 42
If in disuse for several days ..................................................................... 42
CAN bus 43
Hardware ................................................................................................. 43
CAN bus cable - plug assignment ........................................................... 44
System release in network operation ...................................................... 44
Determining user address (Node-ID) and Baud rate ............................... 44
Fault remedying 47
Error diagnosis of the software ............................................................................. 47
General information ................................................................................. 47
Help codes ............................................................................................... 47
Help codes list ......................................................................................... 49
Appearance of errors ............................................................................... 49
Spare parts list 51
Ordering spare parts ............................................................................................. 51
OptiStar CG08(-C) Gun control unit ..................................................................... 52
OptiStar CG08(-C) – Front plate and power pack ................................................ 53
OptiStar CG08(-C) – inside rear wall .................................................................... 54
OptiStar CG08(-C) connections............................................................................ 55