General instructions (control unit attached to instrument)
Instructions for the RPU (detached control unit)
In the manual we will use the following abbreviations for
mechanical resp. servo instruments:
600s = Geodimeter System 600 Pro servo instruments
600m= Geodimeter System 600 mechanical instruments
Some instructions is only valid for instruments equipped with
servo drive (600s). These instructions are indicated by a
shaded field (see below).
If you or your colleagues have any comments about this ma-
nual, we would be grateful to hear from you. Please write to:
Spectra Precision AB
Information & Market Communication Dept.
Box 64
SE-182 11 DANDERYD
SWEDEN
OR e-mail us on info@geotronics.se
E
STD P0 10:19
HA: 154.3605
VA: 106.3701
STD P0 19:12
Searching
**Servo: Rotate the instrument to C1
position by depressing the A/M key in
front for approx. 2 sec. A signal is
heard if the point is marked with a
prism…
Press in front
To Next Page
Loading...