Geodimeter 600 - Battery Charging

2.8.4
POWER SUPPLY CHAPTER 8 GEODIMETER SYSTEM 600
Battery Charging
Spectra Precision AB produces special NiMH and NiCd
battery chargers which should always be used when charging
Geodimeter batteries.
The system contains the following different types of units:
Single Charger (571 906 214)
A 230 or 115 VAC single battery charger. The charger has a
single Hirose output that can handle one NiMH External
Battery (571 204 270) or one NiCd 7 Ah battery (External
heavy duty battery 571 202 194). Use together with Power
Cable 571 908 050 (100-115V), 571 908 051 (230V) or 571
908 052 (230V, UK plug) and Charger Cable 571 208 018
(for the 7Ah battery) or 571 208 020 (for other batteries).
Super Charger (571 906 145)
A microprocessor controlled charger for sequential charging
of up to four Spectra Precision NiMH or NiCd batteries. It is
run with 10-30VDC and is fitted with a connector to suit
both 19mm and 12mm cigarette lighter sockets. It shall only
be used together with Spectra Precision's Power Unit
(571 906 146). The ambient temperature while charging
should be between ±0°C and +40°C. Use together with
Charger Cable 571 208 018 (for the 7Ah battery) or
571 208 020 (for other batteries).
WARNING!!! The Super Charger is for use together with Power Unit
571 906 146 only! Other power units or charging converters must
never be used together with Super Charger.
Power Unit (571 906 146)
A 90-260 VAC charging converter for use together with
Super Charger (571 906 145). The Power Unit is equipped
with a cigarette lighter socket and two Hirose connectors for
Geodimeter system cabling. Use together with Power Cable
571 905 924 (230V), 571 905 925 (100-115V) or
571 908 040 (230V, UK plug).
Note! ☛