1.4.2
CARRYING OUT A MEASUREMENT CHAPTER 4
GEODIMETER SYSTEM 600
This measurement mode is normally used during control
surveys – e.g., small tacheometric exercises, survey point
accuracy control, etc. Measurement time for each point takes
3.5 sec.
Geodimeter System 600 carries out the measurement and
display in P0 of horizontal and vertical angles and slope
distances (HA, VA & SD) with the possibility of also display
horizon-tal distance and difference in height (HD &VD) and
the northings, eastings and elevation of the point by pressing
the ENT-key twice.
Distance & Angle Measurement
Standard measurement (STD Mode)
1
STD
or
STD
1105
1101
To Next Page
Loading...