1.5.2
SURVEYING METHODS CHAPTER 5
GEODIMETER SYSTEM 600
In general
This chapter will describe the different ways of working with
Geodimeter System 600. First of all you can work conventio-
nally with the system. Since the instrument is equipped with
servo drive, you’ll find that the system is very easy to handle,
when setting out you can with a touch of a single key aim the
instrument towards the set out point.
Conventional surveying with servo
If your instrument is equipped with servo drive, this means a
lot of advantages:
• In e.g. setting out you only need to give the point number.
The instrument will calculate and aim automatically
towards the precalculated bearing with a singel press of
the positioning key .
• For angle measurements, just aim towards the different
reflector stations once. The instrument remembers and
repeats the aiming process how ever many times and in
what ever order you want.
• During manual aiming, the servo assists the horizontal
and vertical adjustments. All that’s needed is a light
circular movement of the adjustment screw with your
finger tip.
• Thanks to servo-drive, adjustments screws have no end
positions. That means no unnecessary interruptions, when
aiming.
To Next Page
Loading...