Geodimeter 600 - Radio contact

2.6.4
RADIO CHAPTER 6
GEODIMETER SYSTEM 600
Radio contact
You can establish contact between the RPU and the instru-
ment in two ways:
1. Start the instrument with an attached keyboard unit
a. Choose a channel and an address with menu 15 if it’s the
first time you establish contact.
b. Press the RPU-key.
c. Choose 3. Remote and follow the instructions.
d. The instrument will prompt "Press any key, Remove
keyboard".
e. Remove the keyboard, connect it to the external radio and
press the PWR button.
2. Start the instrument with the A/M-button
With this method you don’t have to attach the keyboard unit
on the instrument.
a. Press the A/M button on the backside of the station unit,
one beep will be heard.
b. 2 beeps will be heard when the radio is on.
c. Press the PWR button at the detached keyboard unit.
Note !
To be able to establish contact between the instrument and
the RPU by using method 2, you must have established
contact using method 1 at least once before, since the
external radio must get the correct radio channel from the
instrument.
Range
The actual range in which the radio can work is depending
on the conditions. Other radios that may be in operation in
your area can decrease the range as well as when working in
an area with many reflecting objects.
Info codes
If the radio contact between the RPU and the instrument can
not be established info code 103 will be displayed. If this
appear, first check that both units are switched on and setup
4
RPU
RPU
or
Note !
If you’ve
powered
off the
system
from the
RPU, the
system
will store
all
para-
meters
for 2
hours.
Restart
simply
by
pressing
PWR at
the
key-
board.