Zoom | 82Functions
Access 1) Press FNC when within any application.
2) Select Control Distance from the FUNCTIONS menu.
CONTROL
DISTANCE
Messages The following are important messages or warnings that may appear.
Next step Press OK to return to the application where FNC was selected.
Field Description
Brg Difference in bearing between the two points.
Grade Difference in gradient between the two points.
hDIST Difference in horizontal distance between the two points.
sDIST Difference in slope distance between the two points.
d.d.Z Difference in height between the two points.
Messages Description
Less than two valid
measurements!
The values cannot be calculated as there are less
than two valid measurements.
To Next Page
Loading...
Need help?
General
