Geotech GEM5000 - Page 127


Page 127 of 127
Operating Manual
OMGEM5KN – Iss. 5.1

Copyright – Geotechnical Instruments (UK) Ltd
GEM5000
Technician ID
An alpha-numeric code tagged to each gas reading.
Facility only available via Gas Analyser Manager (GAM).
This is an optional feature.
Temperature probe
External device used to measure the gas temperature
at the sample point.
This is optional.
Update site data
Enables the operator to answer pre-defined questions
relating to the site, environment etc. These questions
are defined via 5GAM software.
Upload
Terminology used for the movement of data from the
PC via GAM software application to the analyser.
Volume flow rate
The volume of a gas that passes through a given
surface per unit of time e.g. m
3
/hr
Warm-up self-test
Pre-determined self-test sequence to test the analyser
functions which takes place after the analyser is
switched on.
Warranty
The instrument is under guarantee against defect in
materials and workmanship for a period of 3 years
from the date of shipment to the operator and is
subject to the recommended service and recalibration
requirements.
Water trap
Device used to protect the instrument from water or
moisture ingress.
Zero
The point at which the gas analyser is calibrated when
there is none of the target gas present.
Zero transducers
This option allows the relative pressure transducer to
be zeroed.