Geotech GEM5000 - Device Information


Page 41 of 127
Operating Manual
OMGEM5KN – Iss. 5.1

Copyright – Geotechnical Instruments (UK) Ltd
GEM5000
Device information
This option displays default instrument information and settings such as serial number, service
due date, last zero calibration date and last span calibration date.
1) Select the ‘Menu’ key on the front of the analyser to display the ‘Device Settings’ menu.
2) Select ‘Key 3 – Device Information’ and the following screen is displayed:
Device information
3) The information displayed on this screen is informational only and cannot be edited by the operator.
The operator may be asked serial number, service due date and version number information when
contacting Geotech.
Note: The communications setting ‘Legacy’ mode is for use with GAM version 1.5 and above. GA5K mode is
for use with the 5000 series updater tool.
4) Select soft-key ‘Exit’ to exit the screen and return to the ‘Device Settings’ menu.