Setting up alarms/targets
1) Select the ‘Menu’ button on the front of the analyser to display the ‘Device Settings’ menu. Press
the soft key to display ‘Operation Settings’.
2) Select ‘Key 4 – Set Alarms’ and the following menu is displayed:
Set primary alarms
3) Select the corresponding key to select the gas for which you wish to set an alarm/target trigger for,
followed by ‘Key 1’ to change the trigger condition of an alarm.
4) To manually adjust the alarm/target set press (<) ‘Key 4 – Scroll left’ or ‘Key 6 – Scroll right’ (>) and
enter the trigger value. Once you are happy, press the middle soft key for ‘save’.
5) For pressure, temperature and flow alarms, press the left soft key for ‘Secondary’ and then select
the corresponding key to select the channel for which you wish to set an alarm trigger for, followed
by ‘Key 1’ to change the trigger condition of an alarm/target. Once you are happy, press the middle
soft key for ‘save’.
Set secoundary alarms
6) To disable all alarm settings select key 0 – ‘Disable All’
Note: ID specific alarms cannot be added/edited on the analyser, to add/edit ID specific alarms, please use
the optional Gas Analyser Manager (GAM) Software.
To Next Page
Loading...
Need help?
General
