130
Input: Note this function is only supported by cameras with I/O
function. Manually starts I/O monitoring. When the sensor input is
triggered, its associated camera and output will be activated for
recording and alerting. For this setting, see 4.3.1 Input Setting.
[Schedule] The system starts motion detection and I/O monitoring
according to the schedule you have set. For schedule settings, see 4.6
Recording Schedule.
[Camera Status Icon]
: On standby
: Enabled for motion detection and input trigger
: Recording is on.
[Recording Settings] Note this function is only supported by GV-BX12201
firmware V1.02 or later and GV-IPCAM H.265. Configure recording
settings for motion and I/O events, and the condition to record.
Pre-alarm recording time: Activates video recording before an event
occurs. Set the recording time to 1 or 2 seconds. The recording is saved in
the buffer of the camera.
Post-alarm recording time: Activates video recording onto the
inserted memory card after an event occurs. Set the recording time
from 1 to 30 seconds.
Split-interval: Sets the time length between each event file from 1 to
5 minutes.
To Next Page
Loading...
Need help?
General