182
6.1.2 Using the IP Device Utility
The IP Device Utility provides a direct way to upgrade the firmware to
multiple units of the GV-IPCAM. Note the computer used to upgrade
firmware must be under the same network of the camera.
1. Install GeoVision IP Device Utility from the Software DVD, and
follow the onscreen instructions to install the program.
2. Double-click the IP Device Utility icon created on your desktop. This
dialog box appears.
Figure 6-3
3. Click the Search button to locate available cameras on the same LAN.
Or click the New button and assign the IP address to locate the
camera over the Internet. Or highlight one camera in the list and click
the Delete button to remove it.
To Next Page
Loading...
Need help?
General