47
Maintenance cycle counter
Menu item "8.5":
A value between 0 and 99,000, as a multiple of 1000, can be selected for the maintenance
cycle setting.
The maintenance cycle counter reading is reduced by one each time the Open final limit
position is reached.
Once the maintenance cycle reaches zero, the setting from menu item “8.6” is activated.
Short-circuit/overload display
If there is a short circuit or an overload of the 24 VDC supply voltage, the 7-digit display
vanishes.
Standby function
If there is no fault or command pending, the control switches to "Standby".
If the automatic closing duration is longer than 60 seconds. the control also switches to
"Standby"
Only the left dot is lit up.
The "Standby" function is terminated with a command or by activation of the selector switch
"S".
To Next Page
Loading...
