GFA TS 970 - Page 54

54
Status indications
Status
display
Description
Preset value for maintenance cycle counter reached.
Dot on left is not lit: Control circuit has a short circuit or is overloaded.
Function for changing the rotating direction is activated, only possible during initial operation.
Change of rotating direction has been carried out, only possible during initial operation.
Flashin
g
Programming option is blocked.
Flashin
g
Teach in OPEN final limit position.
Flashin
g
Teach in CLOSE final limit position.
Flashin
g
UPWARDS travel active.
Flashin
g
CLOSING operation active.
Stop between the set final limit positions.
Stop at the OPEN final limit position.
Stop at the intermediate stop position.
Stop at the CLOSE final limit position.
Blocking of programming option confirmed.
Flashing display: Unblocking of programming option active.
Interruption of the photo cell function:
At first interruption of the light beam.
Interruption of the photo cell function:
When exiting the programming.