WindMaster and WindMaster Pro 1561-PS-0001. Issue 11 February 2017
________________________________________________________________________________________________________________________
32
Gill Instruments WindMaster 1590-PK-050 Pipe Mount Adaptor.
WindMaster Part 1590-PK-050 is supplied with a Pipe Mount pre-assembled to the base of the WindMaster and with an
installation kit box (part 1590-PK-045) to complete mounting the assembled unit to a pipe.
The Pipe Mount has a smooth internal bore (3.54 inches/90mm in depth) and is designed to mount on a smooth pipe
with a nominal outer diameter of 1.32 inches or 33.4mm. E.g. a pipe with outer dimensions of a one inch national pipe
thread.
Assembly Details.
Mounting.
Open the supplied installation kit box 1590-PK-045 and referring to the above illustration.
Slide on the two supplied 35-45mm Jubilee Clips over the two rubber strips (see above illustration).
Slot the WindMaster into position on to the mounting pipe (engage to depth of 90mm).
Fit the 3 off M5 set screws into three equidistant holes in the pipe mount, see above illustration. Align the unit
North Spar/N marking to North as required (see Page 27, Figure 3) and then tighten the 3 set screws in place.
Tighten and torque the two Jubilee clips in turn, evenly to a figure of 5 Newton/Metres or 45 Pounds/Inch.
Notes:
The M20 Cable gland from the connection box is designed to accept cables with an outer diameter between 8mm to
13mm.
Connect the external cable screen/s to the pillar inside the box using the supplied M4 parts illustrated above.
Appropriate strain relief MUST be fitted to the cable connected through the M20 cable gland - this is particularly
important with pipe mounting.
To Next Page
Loading...
