WindMaster and WindMaster Pro 1561-PS-0001. Issue 11 February 2017
________________________________________________________________________________________________________________________
40
Syncpoll 1 Mode Notes
Syncpoll 1 is set up as follows:-
Open Wind Software.
Type * or *<N> (if already in a polled mode) to enter CONFIGURATION MODE.
Type Syncpoll 1 and press Enter (note there is a space between Syncpoll and 1).
Type Q and press Enter to go to SyncPoll 1 measurement mode.
To check the current Syncpoll setting when in configuration mode type Syncpoll and press return. The unit will respond
with 1 or 0.
Receipt of poll command will trigger a single 50mS or 31.25mS ultrasonic measurement and at the same time will
trigger a Wind measurement output resultant from the previous polled measurement.
The minimum Poll command rate is 20Hz.
Analogue inputs are not supported in Syncpoll 1 mode.
RS485 Networking Examples
Use of a PC with integrated RS485 PCI Card
In tests four WM/WMP were connected to a PC PCI card and using a single RS485 2-wire port 20Hz data was collected
from each sensor. The sensors were set to 57600 baud.
Use of a Data Logger
In tests two sets of two WindMaster (or WindMaster Pro’s) were connected to two individual RS485 2-wire ports on a
data logger that allowed 20Hz data to be collected from all four sensors. The wind sensors were set to 57600 baud,
contact Gill Instruments for further details if required.
To Next Page
Loading...
