1-3
INTRODUCTION
Note: The ‘PASS’ or ‘FAIL’ LED’s indicate the overall result. If
any doubt exists about the obtained result, please contact GMI.
GMI ‘PS200 Settings’ Software is a Windows™ based ‘stand
alone’ application that allows the user to edit test parameters
and view and / or print test results.
This software will run on any PC / Laptop with Windows XP™,
Windows Vista™, or Windows 7™ (32bit or 64bit) software
installed (Net Framework 2.0 or higher may also be required
on early Windows XP™ operating systems).
Both the Auto Bump / Calibration Station and the USB memory
stick are supplied from GMI with necessary ‘PS200 Settings’
software installed. This pre-installed software is congured
to factory default parameters as detailed in the following
chapters. The software conguration parameters can be
edited via PC or Laptop then the settings le transferred to
the Auto Bump / Calibration Station using the USB memory
stick supplied.
The software provides a full audit trail of tested instruments
and the resulting data is retained in the station memory until
downloaded to the USB memory stick, supplied by GMI, before
being transferred to any compatible PC / Laptop for long term
storage, review, and / or printing. The instrument ‘Cal Due’
date is also updated on successful completion of calibration.
A Calibration Certicate can also be generated automatically
after successful completion of instrument testing.
A permanent PC connection is provided via mini-USB socket
at the rear of the Auto Bump / Calibration Station. An Ethernet
socket is also provided at the rear of the unit to allow results
to be gathered over a network. Both of these options require
‘exiCal Plus’ software package, available from GMI.
To Next Page
Loading...
