GMI PS200 series - Connect Gas Cylinder to Auto Bump; Cal Station

2-4
AUTO BUMP / CAL STATION - HANDBOOK
2.1.2 Connect Gas Cylinder to Auto Bump / Cal Station
Connect the On Demand Regulator Valve to the gas cylinder
by screwing the valve rmly into the top of the cylinder, as
illustrated in Fig. 2-4. Fitting is simplied by pressing the valve
on to the cylinder with one hand and turning the cylinder with
the other. Care must be taken not to over-tighten the valve.
Fig. 2-4 Attach Regulator Valve to Gas Cylinder
Connect the barbed adaptor, supplied with the station, to the
other end of the tubing, then push the adaptor into the ‘GAS’
inlet adaptor tting on the rear of the Auto Bump / Cal Station,
as illustrated in Fig. 2-5.
Note: 6mm o/d tubing (not supplied), connects directly into
the ‘GAS’ inlet adaptor tting on the rear of the station.