GMI PS200 series Handbook

1-4
AUTO BUMP / CAL STATION - HANDBOOK
Note: PS200 Bump / Calibration Software is only one part of
the requirement in terms of calibration and maintenance of
a PS200 portable gas detector. Gases, delivery and trained
personnel are all of equal or even greater importance.
The Auto Bump / Calibration Station can also be used to
charge the instrument while power supply is connected. This is
indicated as a ashing battery symbol and ‘CHARGING’
on the instrument display. Charging will take up to 4 hours
to complete. On completion, a full battery symbol and
‘CHARGING COMPLETE’ is displayed.
The instrument will not be damaged if left in Auto Bump /
Calibration Station after charging.
1.2 AUTO BUMP / CALIBRATION HARDWARE
(6mm ttings)
• The Auto Bump / Calibration Station (GMI Part No.
64052) includes 12V output Universal Power Supply
Unit (PSU), and USB Memory Stick with GMI ‘PS200
Settings’ software pre-installed.
• A Test Gas Kit (GMI Part No. 64060) is available as an
accessory and is supplied complete with Combi Test Gas
Cylinder (containing a mixture of 2.5% CH
4
, 500ppm CO,
50ppm H
2
S, 18% O
2
and balance N
2
), On Demand Gas
Flow Regulator and Tubing.

GMI PS200 series Specifications

General

Display	LCD
Alarm Type	Audible, visual, and vibration alarms
Resolution	Depends on the gas being detected
Accuracy	Varies depending on the gas and sensor. Consult the specific sensor datasheet.
Operating Temperature	-20°C to +50°C
Power Supply	Rechargeable Li-ion battery
Pump Type	Built-in sample pump