3-15
VIEW / RE-CONFIGURE SOFTWARE
Firstly, make sure that USB Memory Stick supplied with Auto
Bump / Cal Station is inserted in an available USB port on
your PC / Laptop.
To save changes, position cursor over ‘Generate Settings File’
button then left click mouse to save data to USB Memory Stick.
3.2 TRANSFER UPDATED ‘PS200 SETTINGS’ SOFTWARE
to AUTO BUMP / CAL STATION
Make sure that 12V power supply is connected to the
Auto Bump / Cal Station and switched ON, indicated by an
illuminated ‘ON’ LED on the front of the station and that the
station has completed start-up.
Remove USB Memory Stick from PC / Laptop then insert in
USB port on front face of Auto Bump / Cal Station, illustrated
in Fig. 3-17.
Fig. 3-17 Auto Bump / Cal Station USB Port
To Next Page
Loading...
