A-2
AUTO BUMP / CAL STATION - HANDBOOK
1.2 FIT MOUNTING BRACKET
1. Make sure that workbench surface is clean and free from
dirt and grime.
2. Place clean cloth or similar on workbench to protect
Bump / Cal Station front cover surface from scratching
and / or scufng.
3. Carefully place Bump / Cal Station face down on
workbench. Refer to Fig. A-2.
Fig. A-2 Attach Bracket to Bump / Cal Station
4. Loosely attach bracket to underside of Station with two
pozi countersunk screws (Part No. 24722), as illustrated
in Fig. A-2.
To Next Page
Loading...
