2-8
AUTO BUMP / CAL STATION - HANDBOOK
2.2 CONNECT POWER SUPPLY
Power is supplied to the Auto Bump / Cal Station via a
Universal AC Power Adaptor (12Vdc output) supplied with
the station.
The plug adaptor is located in the 12Vdc socket on the rear
face of the station, as illustrated in Fig. 2-8.
Fig. 2-8 Connect Power Supply to Station
Locate the Universal Power Adaptor in a mains supply wall
socket then switch mains power ON.
The ‘ON’ LED, on the front face of the station, will illuminate
green, as illustrated in Fig. 2-9.
Fig. 2-9 Station ‘ON’ Indication
To Next Page
Loading...
