2-7
CONNECT CALIBRATION GAS AND POWER SUPPLY
Fig. 2-7 Connect Air Tubing Adaptor to Station
The ‘EXHAUST’ line, not illustrated, consists of a length of
tubing and a barbed adaptor, supplied with the station. The
barbed adaptor is a push t in the ‘EXHAUST’ outlet adaptor
on the rear face of the station.
Exhaust tubing can be routed to the nearest window.
Note that inlet and exhaust tubing must be distanced from
each other at end of tubing.
To remove ‘Gas’, ‘Air’ and ‘Exhaust’ adaptors from Auto Bump
/ Calibration Station, depress each blue coloured collar, in turn,
to release then withdraw adaptor and tubing.
To Next Page
Loading...
