4-13
INSTALL INSTRUMENT IN STATION & PERFORM BUMP / CALIBRATION
4.4 AUTO BUMP / CAL STATION FAULT INDICATION
Fault detection indication is via the LED’s on the front face of
the Auto Bump / Cal Station, as follows:
Test Error
A ‘Test Error’ is indicated by a orange ashing LED, as
illustrated in Fig. 4-16.
Fig. 4-16 Test Error
If this fault occurs, it is recommended that the Memory
Stick (Part No. 64184) is inserted into PC or Laptop and re-
congured as detailed in Chapter 3.
On completion, the data should then be transferred to the
Auto Bump / Cal Station.
To Next Page
Loading...
