5-2
AUTO BUMP / CAL STATION - HANDBOOK
5.2 DOWNLOAD TEST RESULTS
Make sure that the Auto Bump / Cal Station is connected to
Mains power supply, switched ON and start-up is completed.
This is indicated by an illuminated green ‘ON’ LED, on the
front face of the station, as illustrated in Fig. 5-2.
Fig. 5-2 Station ‘ON’ Indication
Insert USB memory stick (Part No. 64184) into the USB port
on the front face of the Auto Bump / Cal Station, as illustrated
in Fig. 5-3.
Fig. 5-3 Auto Bump / Cal Station USB Port
To Next Page
Loading...
