GMI PS200 series - Page 33

3-9
VIEW / RE-CONFIGURE SOFTWARE
Gas Measurement Units
Gas measurement units for Carbon Monoxide (CO) and
Hydrogen Sulphide (H
2
S) can be displayed as either ‘ppm’
(default) or mg/m
3
. The unit type selected is reected in Auto
Bump / Cal Station stored data and printed Test / Calibration
Certicate.
To change measurement units, a drop down list is available,
as illustrated in Fig. 3-11.
Fig. 3-11 Measurement Units
Units available for selection are as follows:
ppm (Default); mg/m
3
.
To select measurement type, position the cursor on required
unit type in list, then left click mouse button to conrm.
Selection should match instrument conguration.