3-11
VIEW / RE-CONFIGURE SOFTWARE
If, for any reason, the calibration gas type is changed or the
instrument alarm levels are edited, there may be a requirement
to use a different gas cylinder type and edit test gases.
Calibration Gas Type
To change calibration gas type, a selection of ammable
calibration gases are available, as illustrated in Fig. 3-13.
Fig. 3-13 Cal Gas Selection
Calibration gases available for selection are as follows:
Methane (Default); Propane; Butane; Pentane.
To select calibration gas, position the cursor on required radio
button, then left click mouse button to conrm.
It is important that the calibration gas type reflects the
instrument conguration.
To Next Page
Loading...
