KB300 / KB350 with FS560
Translation of the original operating instruction and spare parts list
- 14-
5006892-01
BA-E
®
3.3 Organisational measures
This operating manual must always be at hand at the place of use of the machine and must be accessible to the
person operating the machine!
In addition to this operating manual, all other generally applicable legal and other mandatory regulations
relevant to accident prevention and environmental protection must be observed! Such obligations may also
comprise the handling of hazardous materials, provisioning and/ or wearing of personal protective equipment, or
road traffic regulations.
This operating manual must be supplemented by instructions covering the duties involved in supervising and
notifying special organizational features, such as job organization, work flows or the person entrusted with the
work. Person entrusted with work on the machine must have read the operating manual prior to taking up work.
This applies especially to persons working only occasionally on the machine, e.g. during set-up or maintenance
activities.
Check - at least from time to time - whether the personnel is carrying out the work in compliance with the
operating manual and paying attention to risks and safety-relevant factors.
For reasons of safety, long hair must be tied back or otherwise secured, garments must be close-fitting and no
jewellery - including rings - may be worn.
Severe injury may result from being caught by moving parts of the machine. Personal protective equipment
must be used wherever required by the circumstances or by law (e.g. safety glasses, ear protectors, safety
boots, suitable safety clothing). Observe the regulations for prevention of accidents! Observe all safety
precautions and warnings attached to the machine and always keep them in good and perfectly legible
condition.
The personal protection equipment should consist of the following parts:
In case event of safety-relevant modifications or changes in the behaviour of the machine, stop the machine
immediately and report the malfunction to the competent authority/ person. Do not remove or make inoperative
any safety devices the machine is equipped with.
Never make any modifications, additions or conversions which might affect safety without GÖLZ
®
GmbH prior
approval! This also applies to the installation and adjustment of safety devices as well as to welding and drilling
work on supporting structures.
Damaged or worn parts of the product must be replaced immediately. Use genuine spare parts only.
All spare parts and tools must comply with the technical requirements specified by the GÖLZ
®
GmbH. Adhere to
the legally prescribed preventive maintenance and inspection intervals or those specified in this operating
manual!
All maintenance and repair activities must be performed by qualified personnel using suitable tools and other
suitable workshop equipment.
1) Hard hat with ear muff
2) Visor or safety glasses
3) Dust mask
4) Protective gloves
5) Safety clothes
6) Safety boots
To Next Page
Loading...