KB300 / KB350 with FS560
Translation of the original operating instruction and spare parts list
- 35-
5006892-01
BA-E
®
Important: Only if there is a noticeable loss of engine power!
6. Maintenance and care
Spare parts must comply with the technical requirements specified by the manufacturer. Spare parts from
GÖLZ
®
can be relied to do so! Observe the following indications:
In accordance to the given cycles, the subsequently described maintenance work has to be enforced. Also the
wearing parts subject to no certain maintenance-intervals have to be checked regularly for wear and to adjust if
necessary or to exchange. With I.C. engines, the maintenance work has to be enforced in accordance with the
separate maintenance-instruction of the engine manufacturer.
work
After work
Weekly
In the event of
a malfunction
If damaged
Machine
x
x x
Clean
x
Threaded spindle Grease
x
Column
Spray with sliding
spray
x
Drill bit
Check
x x
x
Clean thread
x
Repair
x
6.1 Drill rig
Clean the machine and also the carriage well after each duty and check all functions. Replace all necessary
parts that are out of order or worn out immediately. Spray in the column with commercial sliding spray.
6.2 Drill bit
When ending a drill job - check drill bit as follows:
Check segments for cracks or break-outs, Cracks between segment and core barrel, Deformation and
out of round wear.
In case of doubt, send the drill bit for repair (retip). Blunt drill bits should be re-sharpened.
6.3 Replacing the air filter
• Set the choke knob to ▲.
• Loosen the screws (Pos. 1).
Attention: All maintenance, repair and care work is only to be done with the motor being
stopped!
To Next Page
Loading...