KB300 / KB350 with FS560
Translation of the original operating instruction and spare parts list
- 16-
5006892-01
BA-E
®
Important: Wet drilling is to be accomplished while working! This prevents the appearance
of particulate matter and increases the life-time of the diamond tool!
Always keep at a distance from the edges of building pits and slopes. Avoid any operation that might be a risk to
machine stability! Keep the work area clean. Cluttered areas and benches invite injuries! Do not operate when
you are tired! Watch what you are doing! Risk of stumpling! Cables and hoses must complete rolling up. After
assembly do not leave any tools, a wrench for example, on the unit.
Check to see that the tools are removed from the drill rig before operating! Damaged drill bits have to be
changed immediately. Use only recommended drill bits from the GÖLZ
®
GmbH.
Control the working area for water-, gas- and electrical lines!
During work
Make sure, that the drill rig is well fastened before and while drilling!
Never touch rotating parts like drill spindle or drill bit!
After work
Before leaving the machine always secure it against unauthorized use!
3.6 Special work related to the maintenance and repair of the machine
Observe the adjustment, maintenance and inspection activities and intervals set out in the operating
instructions, including information on the replacement of parts and equipment! These activities may be executed
by skilled personnel only. Brief operating personnel before beginning special operations or maintenance work,
and appoint a person to supervise the activities.
In any work concerning the operation, conversion or adjustment of the machine and it’s safety-oriented devices
or any work related to maintenance, inspection and repair, always observe the start-up and shut-down
procedures described in the operating instructions and the information on maintenance work. Ensure that the
maintenance area is adequately secured.
Carry out maintenance and repair work only of the machine is positioned on stable and level ground and has
been secured against inadvertent movement and buckling. If the machine is completely shut down for
maintenance and repair work, it must be secured against inadvertent starting.
To avoid the risk of accidents, individual parts and large assemblies being moved for replacement purposes
should be carefully attached to lifting tackle and secured. Use only suitable and technically perfect lifting gear
and suspension systems with adequate lifting capacity. Never work or stand under suspended loads.
The fastening of loads and the instructing of crane operators should be entrusted to experienced persons only.
The marshaller giving the instructions must be within sight or sound of the operator.
For carrying out overhead assembly work always use specially designed or otherwise safety-oriented ladders
and working platforms. Never use machine parts as a climbing aid. Wear safety harness when carrying out
maintenance work at greater heights.
Clean the machine, especially connections and threaded unions, of any traces of oil, fuel or preservatives
before carrying out maintenance / repair. Never use aggressive detergents. Use lint-free cleaning rags.
Before cleaning the machine with water, steam jet or detergents, cover or tape up all openings which -for safety
and functional reasons - must be protected against water, steam or detergent penetration.
Do not clean the machine with a high-pressure cleaner. The hard water jet can put damage to parts of the
machine. After cleaning, remove all covers and tapes applied for that purpose.
After cleaning check the machine for loose connections, chafe marks and damage! Have identified defects
repaired immediately!
Always tighten any screwed connections that have been loosened during maintenance and repair.
Any safety devices removed for set-up, maintenance or repair purposes must be refitted and checked
immediately upon completion of the maintenance and repair work. Ensure that all consumables and replaced
parts are disposed of safely and with minimum environmental impact.
Attention: Do not clean with high-pressure / splash water! Water / Dirt must not attain into
the exhaust system - engine damage!
To Next Page
Loading...