KB300 / KB350 with FS560
Translation of the original operating instruction and spare parts list
- 18-
5006892-01
BA-E
®
Lifting eye
3.10 Illumination
The machine is designed for use in daylight! The machine operator / owner must ensure sufficient workplace
lighting for non-illuminated work sites!
3.11 Oils, greases and other chemical substances
When handling hydraulic fluids, lubricants, greases or preservatives (referred to hereinafter as fuels and
lubricants), the safety regulations which apply to the respective machine are to be observed!
Avoid long contact of the fuels and lubricants with your skin! Careful cleaning of the skin from adhering fuels and
lubricants is necessary.
Be careful when handling hot consumables (risk of burning or scalding) particularly at liquid temperatures above
60°C, avoid any skin contact with these liquids!
If you get fuels or lubricants in your eyes, rinse them immediately and carefully with potable water. Then consult
a doctor.
Remove flown out fuels and lubricants immediately! Therefore use a binder.
Fuels and lubricants must not seep into the soil or into the public sewage system! Fuels and lubricants which
can no longer be used are to be collected, properly stored and to be properly disposed of.
The respective regulations and laws for handling fuels and lubricants which are valid in the country of use are to
be observed and adhered to. This also applies to the disposal of such fuels and lubricants. To inform yourself
turn to the responsible authorities.
3.12 Transport
Use only suitable means of transport and lifting gear of sufficient capacity when loading or transporting the
machine! Appoint an experienced instructor for the lifting operation!
Always observe the instructions given in the operating manual when lifting the machine (use only the prescribed
lifting eyes for attaching the lifting gear)!
Use only suitable transport vehicles with sufficient load capacity! Secure the load carefully. Use suitable
fastening points for securing!
Before loading the machine or parts of it, secure the machine against inadvertent movement! Attach a suitable
warning sign!
The drill bit must be removed for transport. Even in case of a minor change of location, the engine must be
stopped!
Before using the machine again, make sure that such protection material or devices are properly removed!
Parts which had to be removed for transporting of the machine must be refitted and secured carefully before the
machine is used again!
Before setting the machine in motion always check that all accessories are safely stowed.
The recommissioning procedure must be strictly in accordance with the operating instruction! Observe the
instructions given in the operating instruction when reassembling and operating the machine.
Attention: Check that all parts of the machine are well fastened
before transporting.
Before transport the drill bit must be removed!
For loading only, use lifting gear and tackle of sufficient capacity.
Lift the machine using the lifting eye.
To Next Page
Loading...