KB300 / KB350 with FS560
Translation of the original operating instruction and spare parts list
- 30-
5006892-01
BA-E
®
Important: The connection threads must be clean!
Important: The connection flanges must be clean!
Important: Before fitting the drill bit, carefully clean all the fastening elements!
• Remove the bolts holding the ground frame (3) and remove frame
• Loosen the Nuts (1), left and right of pipe-base, but do not remove!
• Remove 4 Bolts (2) (2 on each side)
• Holding column, to base and tilt the column into required angle
• Secure 4 Bolts by hand
• Turn the ground-frame (3) around the other way and tighten bolts and nuts well.
4.7 Drill bit
The drill bits must meet the specifications of GÖLZ
®
GmbH. Use the appropriate bits depending on the material
to be processed, the working process and the type of work to be carried out! In case of non-intended use, no
liability is assumed for any damage resulting thereof.
All the bits which are used must, as far as their maximum admissible cutting speed is concerned, be designed
for the maximum drive speed of the unit. For units with a variable drive speed use drill bits which, as far as their
maximum admissible cutting speed is concerned, correspond to the respective drive speed. Ensure the right
rotational direction of the drill motor and of the drill bit!
Check the drill bits for proper fit. Defective drill bits must be immediately replaced!
Each time a drill bit is fitted or changed, the drill motor is to be stopped first. After assembly do not leave any
tools, a wrench for example, on the unit.
4.7.1 With UNC-Adapter
Fit the UNC-Adapter firmly to the gear box. Fit the adapter to the gearshaft in such a way that the serration
meshes and screw the two set screws in the adapter into the gearshaft.
Now wind the drill carriage up, but only to such point that the drill bit easily fits under the adapter.
When fitting the drill bit, please observe the following order:
• first the brass disc
• then the O-ring
• finally the drill bit
4.7.2 With 3-hole flange
Fit the 3-hole flange to the gear box. Fit the flange to the gearshaft in such a way that the serration meshes and
screw the two set screws in the flange into the gearshaft. Now wind the drill carriage up, but only to such point
that the drill bit easily fits under the flange.
Then, with a wrench SW 17, screw the three screws M 10 x 20 through the flange into the holes of the drill bit.
Lock the flange with a SW 41 wrench.
To Next Page
Loading...