KB300 / KB350 with FS560
Translation of the original operating instruction and spare parts list
- 22-
5006892-01
BA-E
®
Preparations
On level ground, position the machine so that the filler cap is facing up. Before fueling,
clean the filler cap and the area around it to ensure that no dirt falls into the tank.
Opening screw-type tank cap
Turn the cap counterclockwise until it can be removed from the tank opening.
Remove the cap.
Filling up with fuel
Take care not to spill fuel while fueling and do not overfill the tank!
Cosing screw-type tank cap
Place the cap in the opening.
Turn the cap clockwise as far as stop and tighten it down as firmly as possible by hand.
4.2.3 Air filter
The filter has a very long service life.
Dirty air filters reduce engine power, increase fuel consumption and make starting more difficult.
Replacing the air filter: Only if there is a noticeable loss of engine power!
4.2.4 Winter operation
At temperatures below +10°C
Preheating the carburettor. Repositioning a shutter allows heated air to be drawn in from around the cylinder
and mixed with cold air. This helps prevent carburettor icing.
An arrow (Pos. 1) on the shroud indicates the setting of the shutter (Pos. 2) for summer
or winter operation.
Symbol sun = summer operation
Symbol snowflake = winter operation
Fuelling
Attention: When fuelling on a slope, always position the machine with the filler cap facing
uphill!
Attention: Do not remove the filter cover or replace the air filter as long as there is no
noticeable loss of power!
To Next Page
Loading...