KB300 / KB350 with FS560
Translation of the original operating instruction and spare parts list
- 25-
5006892-01
BA-E
®
4.3.2 By strap and ratchet at exposed pipe
This application is only possible, if the pipe is completely exposed, so that the strap can be wrapped around the
pipe.
The end of the strap that has an „eye“ is attached to the holder by means of a shackle to the notch at the pipe
base. Attach the ratchet to the notch. Pull the strap through the split in the ratchet and stretch the strap by
moving the flap of the ratchet. Pull strap under the pipe. Do not twist the strap!
Releasing the ratchet: Pull up the pawl in the ratchet tensioner. Stretch the ratchet to the point the handle
engages.
4.3.3 Combination of ground spikes and strap
If the ground-condition at the drill-hole side are not convenient you can try a combination of Spikes and Strap as
follows:
• Hit one or two ground spikes on other side of pipe into the ground and wrap the strap around it (them) and
mount the shackle and the ratchet in the two outer notches on the pipe-base and stretch the strap.
• While drilling the operator’s weight should hold the machine down against the pipe. Reduced feed-pressure
should be obtained during this way of operation!
To Next Page
Loading...