GORBEL Destuff-it DTU - Area Scanner Cleaning Procedure

To Next Page

To Previous Page

860-7200-18 DTU DTB Service & Maintenance Manual

AREA SCANNER CLEANING PROCEDURE

IMPORTANT: Only persons who are appropriately trained and

qualied with the safe operation and service of this machine

should be allowed to carry out operation, installation, service or

maintenance� Trained personnel must follow all applicable codes,

laws and standards, both national and local, when conducting any

servicing or maintaining of the machine and associated equip-

ment� Trained personnel should know and follow all national and

local regulations regarding occupational health and safety acts

or regulations� These persons must also have received safety

training to recognize, identify and avoid any hazards involved in

servicing and maintaining the equipment� Service personnel shall

also notify and inform any employee or individual a󰀨ected by the

shutdown and lockout, tag out of the equipment, even if they are

not involved in the service or maintenance work� Service person-

nel must use any protective equipment, protective devices and

clothing required in accordance with all governing acts, laws or

the employer�

1� Ensure the Destu󰀨-it is locked out before attempting to clean

the front area scanner� Please see document “860-6000

Destu󰀨-it Safety Lockout Procedure”�

2� Once the operator platform is in its lowest position, place

wooden blocks underneath the platform� (Figure 1)

3� With a clean, damp, soft cloth, reach under the platform to

clean the scanner� You need to wipe the lens and ledge as

shown below. (Figure 2 – Rear scanner shown. Front scanner

is similar�)

4� After fully cleaned, remove the wooden blocks and resume

normal operation�

NOTE: The front conveyor is NOT considered a suspended load

and will not lower any closer to the oor. The distance from the

platform to the oor is approximately 6 inches.

Small, yellow LED illuminates if

scanner lens or ledge is dirty�

Clean lens and ledge with a clean,

damp, soft cloth�

The ledge is directly beneath the

lens and needs to be cleaned�

Figure 1