Gorgy Timing LEDI Network IN - The NTP Client Software

58
MDE-LEDI-NETWORK-IN-4065V1.0
2. FULL SETUP
1.3.2. The NTP client software
NTP software states
Here are the different states of the NTP client software:
Here is a description of these states:
Starting: ►
The software is starting, it initializes and check the hardware if needed.
Auto-detection: ►
Server auto-detection is activated. The NTP client tries to nd Gorgy Timing ser-
vers. At least one detected server is required to leave this state;
Learning: ►
The NTP client software has found one or several Gorgy Timing (auto-detection ac-
tivated) or works with congured servers. In this state, the software learns network
properties. About 2 minutes are required to complete this stage;
Tracking: ►
Normal behavior, the NTP client permanently evaluate its offset and drift with the
server;
Commuting: ►
Not enough reply received from current server, trying another server.
1. INTRODUCTION
Starng
Auto-detecon
Learning
Tracking Commung
Learning
environment
Searching servers
Enable outputs
No reply
Commuta�on OK
Learning
environment